Leaderboard

Hi chaps, and chapesses. As I get MPU3's in various states of damage one of the most usual things is the cart holder is either missing or broken. As everyone knows without the holder intermittent faults abound due to vibration. Trying to find spare carts is more or less impossible so I thought I'd have a go at knocking up a 3D version. Here's the 2nd attempt, the 1st one the mounting holes spacing were about a 1mm out. I can probably use it but wanted a good one straight off the printer. Having said that it does need a little filing to ease the connector in but everything lines up which is the main objective. I will install it this afternoon and report back but so far all looks good. The rough bits on the bottom are where the supports have to go to enable the raised bit which takes the metal brackets. I cut those off with a small chisel. If there's any interest I'll post the STL file so you can print your own or if you want to improve it. All I ask is you post it back here so I can use it as well.

Hi all, I've blocked all fruit machine sales pages recently but this has been shoved in my face by Facebook as it's just on a general page, not a fruit machine one. I've no idea what it is. It's before my time and no idea if it's electromechanical, microprocessor based, or even who is it made by! Any ideas? Would it be worthwhile picking it up even if just for a project I'll never complete? Seller asking £60 which seems a bit much for what is 99.9% likely a non-worker. Ta!

I have a few 80s mpu4 game cards... I'll.check and let u know tomorrow ..

It's a tantalum capacitor so there's a good chance it has! Snip it off and try it again.

They shouldn't run hot, sounds like a chip has failed unless C1 has gone short?

yes just put it in the working machine and see if it boots up

Definitely electro! If the cabinet is good, it’s probably worth £60, these machines are quite fixable for sure!