Leaderboard

If it's a solenoid sticking then the plunger and the inner sleeve of the solenoid will need cleaning but no oil needed, Check the small hole in the top of the solenoid is clear and not blocked.. Also check the lift arm which is attached to the reel solenoid plunger via a metal link, It has a brass bush and secured to the shaft with a metal clip, you can remove it and apply a small amount of grease to the shaft then refit the lift arm as it needs to be free and not sticking.... If it's the reel drum sticking then it will probably need a reel strip down. Each reel has a clutch which grips the reel drum to spin or nudge the reels, it also slips to reduce the torque on the reel motor allowing it to turn freely when the reels are held in position. The clutches are made of a leather disc which is normally soaked in oil, I use Neatsfoot oil for leather, They dry out over time and causes the reels to stick or slow to start or not spin at all. I soak clutch washers in a jar with oil for at a good 24 hours, the longer the better to allow the leather to soak up the oil, When you rebuild the reel mech, you do not need to refit the clutch washers dripping in oil but dab off the excess. Also while the reels are stripped apply a thin covering of grease to the main reel drive shaft which will lubricate the reel drum bushes so they spin freely too.

And don't forget to regrease the reel motor. I think you'll find that the original grease has gone (off, hard etc.)