All Activity

It's a tantalum capacitor so there's a good chance it has! Snip it off and try it again.

They shouldn't run hot, sounds like a chip has failed unless C1 has gone short?

Will try thanks. The board got really hot after being plugged in for a few seconds.

or take the roms out one at a time and clean the pins but make sure thay go back in the right way

check in that white socket for bent pins

Unbelievable 😂👍.great capture

Cabaret 144 jackpot😂😂😂

My last visit was great. I did a tour video to update you all.

Ah ok thanks

Your going to need to take a picture of the original card, there are a few different sorts!

Hi all after some great advice here it appears I need a replacement program card for my mpu4 board. Think it is a mod2 but the machine is an 80s "stop the clock". Thank you all

Hello everyone. First of all, I want to apologize because I don't speak the language of William Shakespeare. And everything I write is translated with Google. Let me introduce myself: Jean-Michel, 68 years old. French. A little fan of jukeboxes, pinball machines, and slot machines. I have two Barcrests and a Novomatic. A 1982 Barcrest Ambassador. I registered on your site to find information and probably ask questions. Thank you for your welcome and sorry for my poor English.

Hello everyone. First of all, I want to apologize because I don't speak the language of William Shakespeare. And everything I write is translated with Google. Let me introduce myself: Jean-Michel, 68 years old. French. A little fan of jukeboxes, pinball machines, and slot machines. I have two Barcrests and a Novomatic. A 1982 Barcrest Ambassador. I registered on your site to find information and probably ask questions. Thank you for your welcome and sorry for my poor English. jm

Yep power's up straight away. Thanks so much for the advice really appreciate it. Will try and track one down now.

Never thought of that Bob will check

Must be that chip assuming the power is OK to it of course.

Have ordered some 74ls14's hopefully that's the issue

yes just put it in the working machine and see if it boots up

Thanks guys, is the program card the board that sticks out of the main board and are they transferable between machines? The dodgy one is a "stop the clock" and the other one is a "flash cash". Thanks

I have had that very fault with a program card before, have you tried a card from another machine?

broken tracks by the battery as the battery leaks it kills the tracks by it

Club Cops n robbers With mine I have a red LED but no green 12v led lit Checked the power lead from PSU All fuses on PSU are ok Reel led on each reel lit Test switch when pressed does nothing Is there a usual cause with these boards not working? What usually goes when these boards stop working?

could be your program card is fauity

Hi all looking for any advice please. I have an old 80s barcrest machine that when you swith it on nothing happens except some buzzing through the speaker. I have put the power supply and mpu4 board into another machine and both work with no problems so now stuck for ideas. Any help would be very much appreciated. Thanks

I lifted pin12 out the socket but it reads the same! maybe this chip is bad too?