Leaderboard

Just a small project here as i have been having issues with my JPM Hot Pot(MPS1) The main fault was sometimes not accepting certain coins for no reason and the odd missed payout and as the fault was on and off action is needed The fault was caused by the pins in HD10(the coin interface plug) << As can be seen the pins are shot with some of them pushing in << Start the extraction one pin at a time << First pin out << some nice shiny new molex pins ready to go in << Using this way over expensive tool(about £230+vat ) << Pin in tool << First 3 done << And repeat until all pins done << to be safe i did the 50v supply that's on the same loom << fits nice and easy now and no waggling to get the plug on All Done << Machine now works 100% and flawlessly and should be good for another 30 years A small project i know but another repair procedure now worked out

It’s nice to see old threads still being helpful and added to after over a decade. i was in my 40s then and by the end of next week I will be in my 60s.👨‍🦳👴