Jump to content

coin routing??


Recommended Posts

my machine wont take 10p's it has me129 coin mech validator type is a me115ts with a 18 pin routing plug

 

pins connected are pin 4&6 pins 7&18 8&15 and 12&13

 

is this why it wont take new 10ps???

Edited by smccullie
Link to post
Share on other sites

first - change the bulb again - sometimes you get one that has a broken filament because it was bumped about or the 2 wires at the base arent very straight.

 

then it may be the holder if you only have one or 2 bad bulbs.

but it's more likely the diode on the holder.

it should be replaced by a 1N4007 if you change it.

Link to post
Share on other sites
thanks tried a few bulbs and they dont work have loads of spare holders so will try that

 

is it just 1 bulb or do you have more

 

follow the wires from that bulb to next in line both ways and see if they light if they all light then the fault is with the holder, if the wires are attached by spade connectors to the lamp holder ignore the rest, if not and fitted by IDC (which means the wire is pushed between two sharp metal tabs which are wider at the top as the wire is pushed in the outer plastic on the cable is cut so the tabs touch the inner wire and contact)its common for the wire to become loose in the IDC fitting try gently pushing the wire home with a terminal screwdriver

Link to post
Share on other sites
×
×
  • Create New...